Earthway Outlet Spritzer Garden Duster Sprayer - Manual

H
ow to take care of tHe
S
pritzer
™
Garden Sprays will not clog or corrode The Spritzer. When you are through spraying, flush the Spritzer thoroughly with
clean water and allow to dry completely. It is vital to the survival of your garden to thoroughly clean and dry the Spritzer
when you change from a herbicide or weed killer to a pesticide/insecticide. The best solution is to keep one Spritzer reserved
especially for weed killers.
H
ow to repair tHe
S
pritzer
™
After a few years use the Spritzer may loose it’s force. To remedy this follow these directions: 1. Loosen the collar that
connects the inside and outside tubes. 2. Remove the inside tube and the filler cap. 3. Slip the inside tube over a broom
handle and set upright on the floor as shown. [Have a very small flat blade screw driver, or needle nose pliers at this point
to remove the small E-clip.]
4. Push down with both thumbs on the brass retaining washer
and using the screw driver, carefully remove the E-clip from the side, then gently release
the spring pressure to keep the spring and brass retaining washer from flying off. [Once the
E-clip is removed the broom handle will hold the brass valve stem in place for re-assembly.]
5. Replace the worn washers with the new ones from the Repair Kit #60006, first the thick
one, next the four very thin ones, finally the thick smaller washer.
6. Replace the spring. 7.
Replace the brass retaining washer, and then replace the E-clip from the side while pushing
down on the brass retaining washer.
p
art
# D
eScription
13122 Filler Cap
12177 Filler Cap Gasket
18114 Plastic Compression Gaskets
60006 Repair Kit
e-c
lip
i
nStallation
G
arden
d
uster
/s
prayer
Simple, Effortless, Light, and Compact, The Spritzer ™ sprays an extra fine
mist up, under, and right where the bugs live - on the back of the leaves.
Use The Spritzer
™ for liquid or powder to effectively manage pests in your
garden, orchard, or yard. Also great for use with water-based fly spray in the
barn.
H
ow to use tHe
s
pritzer ™
• Remove the filler cap from inside tube and fill with either liquid or dust, then replace the
cap.
• The Spritzer ™ should be completely dry when changing from liquid to dust.
• Push the inside tube down until you feel resistance or hear a click. This opens the valve
and releases a small amount of liquid or dust into the large tube.
• Aim nozzle end of the Spritzer ™ and pump - gentle strokes are best.
• Density of spray is controlled by frequency with which the valve is opened - no need to
hit the bottom with each stroke.
• Force of spray is controlled by the length and vigor of pumping - the longer the stroke the
bigger the spray.
™