Accusys eXpeRAID - Manual (Page 20)

ACCUSYS, INC.
5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
TITLE EXPERAID COMMAND LINE INTERFACE USER GUIDE
PROJECT “DESKTOP RAID” DOCUMENT STATUS OFFICIAL RELEASE
REV. G–05-NOV-2007 PAGE 20 OF 27
3.3.4.3
Command Name Command Description
RebuildParity Use this command to rebuild parity of an array which contains parity.
i.e. RAID 5 or RAID 6.
Parameter 1 Parameter Description
Array No.:
<Array=<1~4>>
Parameter 2 Array No.:
Specify an array number to rebuild parity.
Status setting:
Start or stop the parity rebuilding of the specified array.
Example
State setting:
<State=<Start:Stop>>
CLI>RebuildParity Array=1 State=Start [Enter]
Array 1 will start to rebuild parity if it exists and is configured as
RAID 5 or RAID 6.
3.3.4.4
Command Name Command Description
VerifyParity Use this command to verify parity of an array which contains parity.
i.e. RAID 5 or RAID 6
Parameter 1 Parameter Description
Array No.:
<Array=<1~4>>
Parameter 2
State setting:
<State=<Start:Stop>> Array No.:
Specify an array number to verify parity.
Status setting:
Start or stop the parity verification of the specified array.
3.3.4.5
Command Name Command Description
RefreshArray Use this command to refresh data of the specified array.
Parameter 1 Parameter Description
Array No.:
<Array=<1~4>>
Parameter 2 Array No.:
Specify an array number to be refreshed.
State setting:
Start, stop the array refreshment or just pause the refreshment and
restart it with ‘State=Start’ parameter any time after it has been paused.
Example
State setting:
<State=<Start:Stop:Pause>
>
CLI>RefreshArray Array=1 State=Start[Enter]
Array 1 will start to refresh data if it exists.