Elitegroup EZ-Buddie2 D21 I4-3 Install v.2 - Manual

1
Using your PC
How to Turn on your PC?
1. You can find in the middle part of the front panel two buttons, the one on the right is the
power button and the left is the reset button, and three tuners, and in the lower part of the
panel six buttons and one tuner. You can also find the CD-ROM disk button on the upper
right corner. Just a press on the power button, the system will turn on and start the boot
sequence.
The Installation of Operation System (Optional)
Installation Notes:
1. There are many kinds of operation systems (OS). The most OS is Windows manufactured by Microsoft. Other
choices include Linux OS. Each operation system has a different installation procedure. This manual does not list all
of them. Please refer to the instructions listed in the manual of the operation system purchased.
2. Since no OS is able to provide a complete set of drivers for all peripherals, this PC comes with a driver program CD
for Windows OSs. Once installation of Windows is completed, please insert this CD into the Optical Device Drive and
then the driver program will auto run. Next, the following menu will appear. Please use the mouse to click “Setup,”
and the driver program will start the installation process automatically. During this process, the system will shut off
and on. This is normal. Please follow the instructions shown to complete the installation of all drivers.
How to Use the Card Reader?
1. This PC has a built in 6-in-one card reader that can read CF Card Type I/II, Smart Card, SD Card, Memory Stick, and
MMC Card.
2. Unless your operation system is Windows 98 or older, your PC should be able to operate this card reader without
installing any driver.
3. You can find the corresponding card slots on the right and left side of the main body.
4. All memory cards are handled in the way of inserting and pulling out.
5. This card reader is plug & play, allowing you to insert memory cards at any time and access the cards immediately. In
addition, you can take out the memory cards at any time after reading and writing data to the cards. There is no need
to turn the computer on and off.
Push the button to
start the program