Hired-Hand Light Traps: Light Trap Fan Unit - Manual

During assembly be sure that the motor is not plugged into any power source.
Always double check power sources.
Do not operate fan until you are completely
familiar with its operation. READ ALL
INSTRUCTIONS PRIOR TO INSTALLATION.
When fan is used in life support ventilation system, where failure could
result in loss or injury, provide adequate backup ventilation
or accept the risk of such loss or injury
WARNING:
WARNING:
MAINTENANCE
1. Read WARNING statements before proceeding.
2. Blades, motor and wire guards should be
cleaned periodically to decrease vibration and
ensure maximum fan life. DO NOT SPRAY
MOTOR WITH WATER OR CLEANING
FLUIDS - remove dirt with a dry brush or
compressed air.
3. Fan performance may be greatly reduced by
damaged or dirty shutter. Clean and inspect
shutter periodically to ensure maximum fan
performance.
Disconnect power source before installing
or servicing fan. Failure to disconnect power
source can result in property damage, serious
injury, or death.
CAUTION
Inspect fan for damage in transit.
Check for loose, missing, or damaged parts
BEFORE INSTALLING FAN
Light Trap Fan Unit
TOP
SIDE
Continued On Back
HAZARDOUS ROTATING FAN BLADE HAZARDOUS ROTATING FAN BLADE
HIRED-HAND, INC. HIRED-HAND, INC. 1733 Co Rd 68 Bremen, AL 35033 Phone 205-287-1000 Fax 205-287-2000
Manual Part No. 4801-2990 Manual Part No. 4801-2990
WARRANTY
Your Light Trap Fan has been manufactured with the
finest materials and components available and is backed
by a one year warranty against electrical and mechanical
defects in material and workmanship. If this fan fails to
operate during this period, return it prepaid to place of
purchase for repair or replacement without charge at the
manufacturer's option.
Damage by accident or abuse is not covered by this
warranty.
This warranty gives you specific legal rights and you may
have other rights that vary from state to state.
!
!
WARNING:
!