Hired-Hand Light Traps: 54x54 Light Trap Air Inlet - Manual

54 x 54 LIGHT TRAP AIR INLET 54 x 54 LIGHT TRAP AIR INLET
HIRED-HAND, INC. HIRED-HAND, INC. 1733 Co Rd 68 Bremen, AL 35033 Phone 256-287-1000 Fax 256-287-2000
Manual Part No. 4801-2986 Manual Part No. 4801-2986
Assembly
1. The Light Trap Air Inlet consists of a
galvanized steel Top, Bottom, and two
Side panels which are connected together
to form the Air Inlet assembly. Light Trap
Extrusions are assembled in step 4, and
inserted into the Air Inlet. The assembled
Light Trap Air Inlet is then installed as a
single unit.
2. Fit the two Side panels onto the Bottom as shown
in Figure 1. The edges of the Bottom panel fit
inside the Side panels (See Figure 1). Connect the
panels together using the 1/4 x 3/8 inch bolts
provided in this kit, as shown in Figure 2.
3. Fit the Top panel onto the assembly as shown in
Figure 1. The edges of the Top panel fit to the
outside of the Side panels. Connect the Top to the
Sides by using the 1/4 x 3/8 inch bolts (See Figure 2)..
The two panels having all four edges bent are the
Top and Bottom. Use a tape measure and carefully
measure the lengths of these two panels. The Top
panel is 3/16 inch longer than the Bottom panel. The
two Side panels each have two bent edges, and the
Side panels are interchangeable.
Instructions Continued On Back
Side
Side
Figure 1
4. Assemble the Light Trap Extrusions
which accompany this kit according to
instructions which are included with the
Light Trap Extrusions. Insert the assembled
Light Trap Extrusions into the Air Inlet exactly
as shown in Figure 3.
Top
Bottom
Top
Bottom
Figure 2
Top
Bottom
Figure 3