Hired-Hand Funnel Flow Fans: Light Trap Vent Box Installation - Manual

HIRED-HAND MFG., INC.
• 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 265-287-2000
Manual Part Number 4802-5100 Rev. 4-05 Page 1 of 1
WARNING
Disconnect all Electrical Power before installing the Vent Box.
TOOLS REQUIRED
PART NUMBERS
DIMENSIONS
INSTRUCTIONS
1. Turn off or disconnect all powered cabling to the
Vent Box.
2. Unpack the Light Trap extrusion assembly and
place into the Vent Box. See Figure 1.
3. Cut an opening in the wall based upon the Rough
Opening dimensions shown above.
4. From the outside of the building, insert the Vent Box into the
rough opening and secure with fourteen #12x1" tek screws
(1004-7041). See Figure 2.
5. Attach the Vent Door to the pulley system as required.
6. Installation Complete.
!
Power Drill Level
3/8" Driver Tape Measure
Light Trap Vent Box 12"X44"(6609-8000) Light Trap Vent Box 12"X54" (6609-8001)
Part Number Quan. Description Part Number Quan. Description
6609-1100 1 Vent Door LT 12"X44" 6609-1101 1 Vent Door LT 12"X54"
6624-2501 1 LT-VB-HE 12"X44" 6624-2502 1 LT-VB-HE 12"X54"
6450-5710 1 Hardware Kit 6450-5710 1 Hardware Kit
IMPORTANT!
Locate packing slip and make sure that all listed parts are
enclosed. If not, call your Hired-Hand distributor immediately.
Please read and understand all instructions in this manual
before installing Vent Box.
Light Trap Vent Box Installation
Light Trap Vent Box Dimensions Vent Box Rough Wall Opening
Vent Box Size Part Number W H D Width Height
12" X 44" 6609-1100 44-5/8" 12-1/2" 12" 45-1/8" 13"
12" X 54" 6609-1101 54-5/8" 12-1/2" 12" 55-1/8" 13"
Vent Box
Vent
Door
Wall
AIR IN
Figure 2 Install Vent into Wall
Vent Box
Light
Trap
Vent
Door
W
H
D
Figure 1 Install Light Trap in Vent Box