Hired-Hand Mega Flow SlantWall Fans: Belt Guard Installation - Manual

HIRED-HAND, INC.
• 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 265-287-2000 Page
Manual Part Number 4802-5099 Rev 11-04
1
Assembly Instructions
1. Turn off all power to the fan.
2.
Place the Belt Guard over the Pulley Assembly and align the four
Guard mounting holes with the four fan braces. See Figure 1.
3.
Mark the location for the four mounting
screws on the fan braces. See Figure 2.
4.
Remove the Belt Guard and drill four 1/8” holes for the
mounting screws. See Figure 3.
5.
Replace the Belt Guard and install with the four tek screws and
washers provided. See Figure 4. NOTE: If the motor shaft
touches the Belt Guard, add two washers between the Belt
Guard mounting lugs and the fan braces.
6.
Apply power and verify proper fan operation.
NOTE: Ensure that no moving parts make
contact with the Belt Guard. 7. Installation Complete. See Figure 5
Tools Required: 3/8" Nut Driver
Drill 1/8" drill bit
Belt Guard Installation
Belt Guard Kit
Part Number Description
6403-0149 Guard PVC Belt
1004-0050 Screw #14 Tek z
1003-1461 Washer Flat ¼" zinc
IMPORTANT!
Locate packing slip and make sure that all
listed parts are enclosed. If not, call your
Hired-Hand distributor immediately. Please
read and understand all instructions in this
manual before assembling fan.
CAUTION!
Turn Off all Power to the fan before installing the Belt
Guard.
Figure 1 – Position Guard
Figure 2 – Mark Mounting Holes
Figure 3 – Drill Four Holes
Figure 4 – Install Tek Screws
Figure 5 – Completed Installation
Belt Guard
Mounting Holes
on Fan Brace
Fan Brace
Add two washers
between fan brace
and belt guard if
necessary
Motor Shaft