Hired-Hand PowerTrak: SPROCKET DRIVE ASSEMBLY - Manual

HIRED-HAND MFG., INC. • 1733 Co Rd 68 • Bremen, Alabama 35033 · Phone 256-287-1000 • Fax 256-287-2000
Part No. 4801-5096 Rev 6-06 Page 1 of 3
WARNING
Disconnect All Electrical Power Sources To Machine Before Reaching Inside Unit.
Tools Required 7/16 ″ Socket 3/8 ″ Ratchet and extensions ¼”Nut Driver
1/ 2” Socket 9/16 “Socket Small screwdriver 7/16 “ Wrench
Directions
Pulley Assembly Removal
(See Figure 1):
(1)
Disconnect all Electrical Power from
the Power Trak
™.
(2)
Disconnect all curtain cables from the
Power Trak
™ load block, and remove
the cables completely from the unit.
(3)
Unscrew the four sheet metal screws
(A) holding the top. Retain screws for
use when re-assembling.
(4)
Remove the cabinet top (B).
(5)
Unscrew the eight Hex head bolts (C)
from the left and right sides near the
top cover.
(6)
Remove the pulley assembly (D).
Retain bolts and nuts for use later
when reassembling. Note: If there are
lag bolts in the mounting holes (E),
they will need to be removed.
(Instructions continued on next page.)
INSTALLATION INSTRUCTIONS
SPROCKET DRIVE ASSEMBLY
PowerTrak
™
Figure 1
Remove Pulley Assembly
!