LumaSense Technologies LumaSHIELD Controller Installation Guide: Spacer Disk User Manual

Instructions, Purpose, Lumasense technologies awakening your 6

Advertising
background image

[email protected]

www.lumasenseinc.com

©2013 LumaSense Technologies. All rights reserved.

LumaSense Technologies, Inc., reserves the right to change
the information in this publication at any time.

Americas and Australia
Sales & Service
Santa Clara, CA
Ph: +1 800 631 0176
Fax: +1 408 727 1677

Europe, Middle East, Africa
Sales & Service
Frankfurt, Germany
Ph: +49 69 97373 0
Fax: +49 69 97373 167

India
Sales & Support Center
Mumbai, India
Ph: +91 22 67419203
Fax: +91 22 67419201

China
Sales & Support Center
Shanghai, China
Ph: +86 133 1182 7766
Fax: +86 21 5877 2383

LumaSense Technologies

Awakening Your 6

th

Sense

LumaSHIELD Installation Guide - Spacer Disk-EN 514-0005-01 Rev. A 10/14/13

LumaSHIELD Installation Guide: Spacer Disk

Instructions

1. As shown in Figure 1, use polyimide tape to hold the

probe tip on a hot plate and put the spacer disk in
position. The location of the spacer disk depends on
the paper board structure (Refer to Figure 2).

2. Turn on power of the hot plate and warm the tem-

perature to around 93 °C.

3. Mix the two-part epoxy Aremco 631 with weight

ratio 1:1.

4. Use a piece of optical fiber or a toothpick to apply

the epoxy to the gap between the fiber and the
spacer disk as shown in Figure 1.

In case of epoxy flowing onto the hot plate, the
epoxy should be applied several times. For example,
apply once and cure it for 10 minutes and apply it
again until the epoxy filled the gap. After two hours
curing, the epoxy should be flush to the spacer disk
surface.

Figure 1: Spacer Disk Installation

Figure 2: Illustration of Paper Board

Purpose

This procedure is for installing the spacer disk onto the OTG-T (or OTG-T+) probe.

Advertising