Autostart CT-1010 - Manual

Keyless Entry And Alarm System
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the Unit.
This Unit must be installed by a certified technician using all safety devices supplied. Only
registered technicians will be eligible to use the Prostart technical support telephone
service. Please review the Installation Guide carefully before beginning any work
.
DOC: 1.06 November 10, 2006 TL Manufactured in Canada by Autostart
CT-1010
Installation Guide
Table of Contents
Included in the Kit........................... 1
Installation Points to Remember .. 2
Programmable Features.................. 2
Harness Description......................... 3
How to Flash the Hood Pin........... 4
Programming a Transmitter........... 4
Programming Options .................... 4
Dome Light Delay............................ 7
Retain Accessory Output............... 7
Zone 2 Disable Output .................. 7
Multi-car Operation ........................ 7
Resetting the Module...................... 7
Diagnostics - Parking Lights Flash
Rate ..................................................... 8
Closing Up......................................... 8
Included in the Kit
Please review the installation guide before beginning the installation, especially the wiring diagram and the
programming options. It is very important that you familiarize yourself with the programming and operation of
the system, even if you have already installed an alarm system in the past. There are many great new features
that may be overlooked if the manual is not read: you would therefore not maximize the unit’s potential. Prior to
the installation, make sure that all the hardware components required to install the system are in the box.