U.S. Sunlight 1015APV Purpose Ventilator - Manual

Installation and Mounting Guide
923 Tahoe Blvd, Suit 110
Incline Village, NV 89451
Tel: 877-50-USSUN
www.ussunlight.com
[email protected]
Thank you for purchasing the All Purpose Ventilator from U.S. Sunlight Corp.
We are committed to providing alternative energy products that can improve your
everyday life and our environment. We have reduced packaging material and
eliminated Styrofoam to reduce the impact on landfills. We offer an installation
video that is available to view online at www.ussunlight.com.
If there is a problem with your U.S. Sunlight product call us at 1-877-50-USSUN.
Spare parts, installation advice, or recommendations for professional installers
in your area are only a phone call away. Professional installation may be much
less than you expect, please call us to get average rates for your area.
Before beginning the installation of your new All Purpose Ventilator, please read
through the entire installation instructions and call us if you have any questions.
MINIMUM TOOLS REQUIRED
BOX CONTENTS - Unpack and
check. You should have:
A - Fan assembly
B - Solar panel with 30 ft. of attached wire
C - Wall mounting brackets (2 ea)
D - Mounting bracket bolt and nut (4 ea)
E - 1.5” screws for fan mounting (8 ea)
* Some models include a thermal switch
in the fan assembly
• Power drill with phillips head
driver and an 1/8” drill bit
• Adjustable wrench
• Measuring tape
• tin snips or wire cutters
(for cutting hole in vent screen)
• Circular saw or handsaw
(for cutting 2x4s for bracing if req.)
• pencil or marking pen
• 1/4” coaxial staples
(for securing the wire after installation)
• caulk gun with roofing adhesive
D
E
A* B
C D
4 each
8 each
© Copyright 2014 All Purpose Ventilator C01 ver4
Optional Hardware (not included)
Fan mounting options:
• 3” galvanized deck screws
(for mounting 2x4 braces to framing members if req.)
Panel mounting options: (roof mounting)
• 2” pan head tapping screws
(for mounting to composition roof)
• caulk gun with roofing adhesive
(for mounting solar panel directly to s-tile, flat tile or metal roofs)
Panel mounting options: (wall mounting)
• 1.5”- 3” anchor screws (depending on your specific type of
stucco, cement or brick wall. Must support up to 20 lbs)
• 1.5”- 3” galvanized screws (depending on your specific
type of wood or vinyl siding. Must support up to 20 lbs)
• caulk gun with roofing adhesive
(for sealing screw heads when mounting to wood or vinyl siding)