U.S. Sunlight 1010APV Wire Extension Kit - Manual

Wire Extension Kit
Installation Guide
For Models 9910APV & 1010APV
Installation of the Wire Extension Kit
US Sunlight Corp. 5625-B Brisa Street, Livermore, CA 94550 1-866-446-0966
www.ussunlight.com
Step 1: Connect the female
connectors of the Wire Extension
kit directly to the fan motor as
described in the APV installation
instructions (fig. 1).
Step 2: Insert the male connectors
from the Wire Extension Kit into the
female connectors at the end of
the solar panel wire (fig. 2)
Step 4: Place the black wire
connection into the remaining
opening in the protective casing
(fig. 4).
Step 5: Press the casing down
over the black wire and snap shut
(fig. 5).
Step 3: Slide the red wire connection
into one of the protective casings (fig.
3). Press the casing down over the
red wire firmly and snap shut (fig. 5).
Step 6: The wire extension
connection is now secure and
weather-proof (fig. 6).
The Wire Extension Kit provides up to 30 feet of additional wiring for remote-mounting your solar panel
on a roof top, wall, or fascia board. Up to two Wire Kits (60 feet) can be added to a panel (which
already includes 30 feet of wire), for a maximum of 90 feet between the panel and the fan.
Note: Do not add more than two Wire Kits, or exceed 90 feet total distance between the Panel and the
Fan, the result could be reduced performance.
fig. 1 fig. 2 fig. 3
fig. 4 fig. 5 fig. 6