Work Sharp WSKTS-KO Tool Grinding Attachment - Manual

Hub Fastener
(Left-Handed Thread)
Ball
Detent
Platen Grind
Slack Grind
Quick Lock
Tensioner
(A)
(B)
Pulley Drive Hub
Quick Start Guide
Tool Grinding Attachment
Get to Know Your Tool:
Installation: Sharpening:
Belt Information:
1. Install Pulley Drive Hub onto tool using provided
Left-Hand Thread Hub Fastener – turn LEFT to tighten and
RIGHT to loosen, do not over-tighten fastener. Be
sure the Pulley Drive Hub is properly aligned onto the
keyed motor shaft.
2. Install metal Tool Grinding Attachment onto power
platform at Position A. Press FIRMLY inward to depress
ball detent, then rotate forward to Position B.
3. Push in and turn tensioner to install / uninstall belt.
• Avoid overheating tool.
- Allow tool to cool to room temperature
between rated operating periods.
• Speed Setting: Use at full speed for
optimum performance.
• Always secure work piece and wear eye
protection when grinding.
• Keep tool and attachment clean for
optimum life and performance.
Push lock release
lever and rotate knife
sharpening cassette
to position shown.
Pull outward to
remove cassette.
Extra Coarse | P60
The P60 Zirconia Alumina belt
from Norton is designed and
intended for grinding tasks.
Deburr Pipe
Sharpen a
Mower Blade
Video Demos and Replacement Belts Available at:
WORKSHARPTOOLS.COM