General menu – HT instruments SOLAR300N User Manual

Page 13

Advertising
background image

SOLAR300 - SOLAR300N

EN - 11

5. GENERAL MENU

Whenever you turn on the meter, the below “Analyzer Configuration” screen is shown,
relative to the last configuration used (see Fig. 6):

Fig. 6: Example of analyzer configuration

In this situation the user can decide whether modify the actual configuration by pressing
F1 key (or “CHANGE” at display – see § 5.3.1) or directly access to General Menu by
pressing F4 key (or the “OK” at display). If no action is performed within 10s the meter
automatically goes to GENERAL MENU screen.
The GENERAL MENU of meter is correspondent to the screen shown in (see Fig. 7):

Fig. 7: GENERAL MENU screen

The actual selected section is shown with red background at display and it’s title is shown
in the bottom of display. The below sections are available on meter:
General settings section which permits to set the system parameters of meter as

date/hour, language, display brightness, protection password, keys sound on pressure
auto power off and memory type (see § 5.1).

Real time values section which permits to see the real time measured values at

display under various formats (see § 5.2).

Analyzer settings section which permits to define the simple and advanced

configurations relative to connection of meter to the installation (see § 5.3).

Recorder settings section which permits to select the parameters for each recording

and see the information about the autonomy of meter during operation (see § 5.4).

Recording results section which permits to see the list of all recordings saved on

internal memory, for memory cancel operations and the transfer of date in external Pen
Driver USB (see § 5.7).

Meter information section which permits to access to general information about meter

(serial number, internal Firmware and Software release, etc...) (see § 5.8).

Advertising
This manual is related to the following products: