HT instruments SOLAR300N - Manual (Page 52)

SOLAR300 - SOLAR300N
EN - 50
5.3.3.3. Setting of minimum irradiance threshold
This option allow to set the minimum irradiance threshold used by meter as reference
during measurement.
1. By means of the F3 or F4 key (or items MOD(+) or MOD(-) on the display), select the
desired value within the range 400
 800 W/m 2
2. Press the SAVE or ENTER key (or the smart icon ) to save the selected setting by
confirming with “Ok”. In this way, the settings made will remain valid also after turning
off the instrument
3. To quit the settings made or to exit without saving, press the ESC key (or the smart
icon )
5.3.3.4. Setting of corrective constant of DC clamp
This option allow to set the corrective K factor relative only to the supplied HT4004 DC
clamp which is indicated on the label in the backside of clamp (see Fig. 102)
In case no label is present, set k = 1.000
Fig. 102: Set of corrective constant for DC clamp
CAUTION
For HT4004 DC clamp which do not have the label with the corrective constant
K and for other type of DC clamps do not modify the 1.000 factory value
1. By means of the F3 or F4 key (or items MOD(+) or MOD(-) on the display), select the
desired value within the range 0.950
1.050
2. Press the SAVE or ENTER key (or the smart icon ) to save the selected setting by
confirming with “Ok”. In this way, the settings made will remain valid also after turning
off the instrument
3. To quit the settings made or to exit without saving, press the ESC key (or the smart
icon )