HT instruments SOLAR300N - Manual (Page 66)

SOLAR300 - SOLAR300N
EN - 64
5.4.2.4. Integration period
This option permits to set the integration period (see § 10.11.1) which is the time interval
between two sequential recordings within the global duration of measurements. The flag of
this option is always active and not disabled.
1. Move the cursor using arrows keys on field relative to “Integration period” , marked it
with blue background.
2. Press F4 key (alternatively touch the MODIFY at display). In the bottom of display a
command bar with “Integration Period” is shown.
3. Press F3 key (MOD(+)) or F4(MOD(-)) or up and down keys to set the desired
integration period choosing among the below values: 1s, 5s, 10s, 30s, 1min, 2min,
5min, 10min, 15min, 30min, 60min.
4. Press SAVE key or ENTER key (or the smart icon ) to save the settings. The
integration period value is shown at display.
5.4.2.5. Cogenerations
The selection of this , effected both by using up or down arrows keys and directly selecting
the flag at display, enters the values of powers and energies generated (co-generation) in
the list of recorded parameters (see § 10.10.1).