HT instruments SOLAR300N User Manual

Page 89

Advertising
background image

SOLAR300 - SOLAR300N

EN - 87

5.5.2. Stop a test
To stop a test (after connecting the unit SOLAR-0x or the unit MPP300 to the main unit),
press the F1 key. The icon highlighted in Fig. 140 disappears from the display.

After the automatic data transfer phase, the instrument will automatically display:

 The maximum performance outcome (max PRp), according to § 5.3.2.6

or

 Will shows the message “Results don't comply with minimal test requirements” if the

Irradiance values were not steady or never reach minimum Irradiance value.


Press:

SAVE:

to save the results obtained. Pressing the key will display the virtual keyboard
for typing possible comments. A further pressing of the SAVE key will store
the measure and the typed comments and will go back to the initial screen,
ready for a new measurement. The data will be recorded in a RegPV file and
you’ll have the possibility to view them on the display at all times (see § 5.7.2)

ESC: to

delete the detected data and go back to the initial screen, ready for a new

measurement.



Advertising
This manual is related to the following products: