HT instruments VEGA78 - Manual (Page 24)

VEGA78
EN - 22
25/01/2013 – 16:55:10
TOT. ENERGY PRODUCTION – Page x/y
Eact = 0 kWh
Ppeak = 0 kW
Date Ppeak : -- / -- / -- 00:00:00
Start rec. : -- / -- / -- 00:00:00
Stop rec. : -- / -- / -- 00:00:00
Rec Time : - - -
Int. Per. : - - - Rec: - -
PAGE SCOPE HARM VECTORS
PARAMETERS CAPTION:
Eact
 Total active energy produced when starting
recording.
Ppeak
 Maximum peak of produced active power.
Date Ppeak  Date and time in which the peak occurred.
Start rec.  Date when recording was started.
Stop rec.  Date when recording was stopped.
Rec Time  Time elapsed from Rec Start.
Int. Per.  Value of the set integration period.
Rec  Number of the recording in progress
Fig. 33: Producted energy page
CAUTION
The Total Produced Energy page is shown only if recording parameter “Co-
generation” has been set in the instrument (see § 5.4.5) and if general
parameter Total “Active Power & Energy” has been selected (see § 5.4.6.1).
Values will be shown only during or at the end of a recording and zeroed
upon starting a new recording or when the instrument is switched off.
5.2.3. 3-wire ARON three phase system – Screens sequence
12/09/2006 – 16:55:10
TOTAL RMS VALUES – Page x/y
V12
0.0
V23
0.0
V31
0.0 V
NEG%
0.0
ZERO%
0.0
SEQ
000
Hz
0.0
I1
0.0
I2
0.0
I3
0.0 A
PAGE SCOPE HARM VECTORS
PARAMETERS CAPTION:
V12
 Phase L1 – Phase L2 voltage
V23  Phase L2 – Phase L3 voltage
V23  Phase L3 – Phase L1 voltage
NEG%  Unbalance percentage of negative tern
ZERO%  Unbalance percentage of zero tern
SEQ  phases sequence indication as:
”123” = > Corrected
”132” = > Reversed
”023” = > Null voltage on the Black wire
”103” = > Null voltage on the Red wire
”120” = > Null voltage on the Brown wire
”100” = > Null voltage on the Red and Brown wires
”020” = > Null voltage on the Black and Brown wires
”003” = > Null voltage on the Black and Red wires
Hz
 Frequency
I1  Current on L1 phase
I2  Current on L2 phase
I3  Current on L3 phase
Fig. 34: Page of numerical values
12/09/2006 – 16:55:10
WATTMETER12 – Page x/y
V12
I1
Patt12
Preatt12
Papp12
Pf12
CosPhi12
=
=
=
=
=
=
=
0.0 V
0.0 A
0 W
0 Var
0 VA
0.00i
0.00i
PAGE SCOPE HARM VECTORS
PARAMETERS CAPTION:
V12
 Phase L1 – Phase L2 voltage
I1  Current on L1 phase
Pact12  Active Power Wattmeter 12
Preact12  Reactive Power VARmeter 12
Papp12  Apparent Power VAmeter 12
Pf12  Power Factor Wattmeter 12
CosPhi12  Power Factor between fundamental of
 voltage and current Wattmeter 12
Fig. 35: Page of numerical values Wattmeter-Varmeter 1-2