In-Situ Con TROLL PRO Operators Manual (purchased before 10 May 2012) User Manual
Troll
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- ChapterTitle - Chapter 1 Getting Started
- Heading1 - 1.1 Sensor Installation Requirements
- Heading1 - 1.2 Navigating Through the Menus
- Heading1 - 1.3 Initial Configuration
- Heading1 - 1.4 Using the View Function
- Heading1 - 1.5 Changing the Date and Time
- Heading1 - 1.6 Display (Screen) Appearance
- Heading1 - 1.7 On-Screen Icon Descriptions
- Heading1 - 1.8 Changing the Power Settings
- Heading1 - 1.9 Set the Polling (Update) Interval
- Heading1 - 1.10 Setting the Communications Preferences
- Heading1 - 1.11 Administrator and Password Access
- ChapterTitle - Chapter 2 Configuring Probes
- Heading1 - 2.1 Adding a Probe After Initial Configuration or Deletion
- Heading1 - 2.2 Deleting a Probe
- Heading1 - 2.3 Replacing a Probe
- Heading1 - 2.4 Enabling and Disabling Parameters
- Heading1 - 2.5 Setting Parameter Units
- Heading1 - 2.6 Setting Parameter Resolution (Setting the Decimal Place)
- Heading1 - 2.7 Setting the Sentinel Value (Offline/Error Value)
- Heading1 - 2.8 Configuring RDO PRO Options
- Heading1 - 2.9 Configuring Level TROLL Options
- Heading1 - 2.10 Configuring Aqua TROLL Options
- ChapterTitle - Chapter 3 Calibrating the Probes
- ChapterTitle - Chapter 4 Outputs and Relays
- ChapterTitle - Chapter 5 Logged Data
- Heading1 - 5.1 Viewing Logged Data
- Heading1 - 5.2 Downloading Data Using Win-Situ® 5 and a PC
- Heading2 - 5.2.1 Configuring the Bluetooth® Utility for PCs with Factory-Enabled Bluetooth Communications
- Heading2 - 5.2.2 Configuring the Bluetooth® Utility for PCs Not Factory-Enabled with Bluetooth Communications (Example)
- Heading2 - 5.2.3 Connecting a TROLL Com Communication Cable to the Controller (Bluetooth Alternative)
- Heading2 - 5.2.4 Connecting the Con TROLL PRO to Win-Situ® 5 Software
- Heading1 - 5.3 Downloading Data Using Win-Situ® Mobile and a RuggedReader® Handheld PC
- Heading1 - 5.4 Special Hints
- ChapterTitle - Chapter 6 Troubleshooting
- Heading1 - 6.1 Finding Serial Numbers, Firmware and Hardware Versions, Calibration, and Power Information
- Heading1 - 6.2 Special note regarding RDO sensor cap replacement
- Heading1 - 6.3 Finding Calibration Data and Constants
- Heading1 - 6.4 Troubleshooting Power Issues
- Heading1 - 6.5 Troubleshooting Probe Connection Issues
- Heading1 - 6.6 Troubleshooting Bluetooth® Communications Issues