Hoyles Two LEDs and Button with special text Stainless steel User Manual
Hoyles electronic developments ltd, S0610 mounting spacer
35mm
7mm
2mm
If stainless steel units are to be fitted in
areas where they may be subjected to
deliberate attack they should be recessed
below the surface of the wall. A cavity
should be constructed as shown. The
galvanised socket box should be fitted to
ensure that the box is totally secure. The
cable entry should be either rear or side
e n t r y . F o r i n i t i a l t e s t i n g a n d
commissioning use conventional M3.5
countersunk fixing screws to secure the
plate. When it has been established that
the system is working correctly replace
these screws with security screws. A gap
filling epoxy cement should be used to
form a seal between the stainless steel
plate and the wall.
S0610 Mounting Spacer
Although Stainless steel units are generally intended
for flush fitting using the galvanised box provided
they can be surface mounted using the S0610 mock
stainless steel mounting spacer.
The galvanised box should be mounted in the
required position and the cable entries made. The
S0610 spacer is then placed over the box, the
relevant terminations made off and the plate screwed
down on to the box. The spacer is therefore gripped
between the wall and the plate.
Water Proof Mushroom headed push
buttons are available as latching twist
to reset in red and non-latching green.
Both are IP65 rated. They can be fitted
with a text label of your choice. Please
ensure units are properly sealed after
installation to ensure Ip65 rating is not
compromised and prevent water
ingress.
Epoxy Cement
NO
COM
NC
Bz -ve
-ve
12v+ve
24v+ve
-ve
12v+ve
24v+ve
-ve
12v+ve
-ve
LED
+ve
Blue
Yellow
White
Red
Red
Red
Red
Black
Black
Black
Black
Dwg No. 60131 Iss 1 June 2011
With the exception of S1711WP and S1712WPG all items are dimensionally
compatible with single gang BS4662 fittings.
Switches and pushbuttons are designed for use on low voltage
systems AC or DC. NOT to be used on 240v mains. LEDs are fitted with current limit
resistors suitable for 12vdc operation. Higher voltage operation, typically 24vdc, is
available to special order and connection details are shown below.
Note: LEDs should only be powered from a DC source. If AC is to be used a small
diode typically 1N4001 should be connected in series.
All are supplied with a galvanised box for
flush mounting..
S0610 Mounting Spacer
Galvanised Box
Stainless Steel Plate
Connection for 12vdc
Connection for 24vdc (Special Order)
Diode for AC operation to be fitted on
installation
Jumbo LEDs follow this colour code
convention
and where fitted, a sounder follows
this convention
WARNING! The stainless steel version may have sharp edges. Please
exercise care when handling and during installation.
Pushbuttons or Keyswitches follow
this colour code convention
T. 01744 886600 F. 01744 886607 E. [email protected] W. www.hoyles.com
Hoyles Electronic Developments Ltd
1 NC 2
1
N
O
2
S1711WP S1712WPG
Mushroom headed pushbuttons on
stainless steel plates have single pole
normally closed contacts. They can be
fitted with an additional normally open
or normally closed contact which are
available separately.
Optional