JJC WR-100 - Manual

1
JJC WR-100 WIRELESS CONTROLLER
Thank you for purchasing JJC WR-100 series wireless controller. For the best performance, please
read this instruction carefully before using.
Remove the remote control socket cap of the camera.
Take out the JJC WR-100 wireless controller receiver and plug it into the remote control socket of the
camera.
Slide the function button in the W Mode. The receiver is active. Under this condition, the receiver can
receive the signal from the transmitter; the receiver consumes the power of the battery. User can uses
the Shutter button of the transmitter and Focus button to control the Camera’s shutter and Focus.
Press the transmitter’s Shutter button to take a photo. Press the transmitter’s Focus button to focus.
Slide the function button in the O Mode. The receiver is turnoff. Under this condition, the transmitter
can not active the receiver to control the camera. The receiver will not consume any power of the
battery. User can use the shutter button of the receiver to take photos. Press the shutter button
halfway to focus. Press it fully to take a photo.
Slide the function button in the L Mode and turn on the camera to BULB mode. Under this condition,
the transmitter opens the lens; Slid the function button in the O Mode, the transmitter closes the lens.