Home screen – Setra System SRCM User Manual

Page 5

Advertising
background image

5

The default screen now has 2 possible modes. Now if the user wants to display other

room variables in addition to Pressure they can switch to the screen below that shows

up to 4 parameters per room. These can be Pressure, Temperature, Humidity, and user-

defined. The User switches modes by selecting slider on/slider off on the bottom of the

administrative menu.

The Home screen is the normal continuous operating mode of the SRCM. The Home

screen shows a Condition Banner on the left one-third of the screen, and Operating Con-

ditions on the right two-thirds of the screen.

There are two possible home screens, one

with a pressure only display with a slider bar representing the room pressure with respect

to the alarm setpoints. The other alternate home screen can be used when there are mul-

tiple parameters other than pressure such as temperature and humidity as well as a fourth,

which is user defined,

that also can be displayed.

Pressure Value

Slider Bar and Setpoint Values

Condition Banner

Room Label

Pressure Mode

• Positive

• Negative

• Neutral (span)

• Standby

Operation

• Normal (green)

• Warning (yellow)

• Door (yellow)

• Alarm (red)

Alternate Home Screen displaying multiple

parameters, in addition to pressure.

Home Screen

Room Label

Pressure Mode

• Positive

• Negative

• Neutral (span)

• Standby

Operation

• Normal (green)

• Warning (yellow)

• Door (yellow)

• Alarm (red)

Pressure

Temperature

Humidity

User-defined

Condition Banner

Home Screen

Advertising