Setra System SRCM - Manual (Page 7)

7
Once the messages of each of the four Condition Banners are defined in the Menu
section, the user can cycle through all four conditions by simply touching the left one-
third of the screen in any region. If passwords are enabled, the user will be prompted
to enter their password before proceeding. Each of the four colored screens can have
a unique message defined. See Section: Setup Display, page 11, for instructions on
how to setup the Condition Banner.
When alarm occurs the Condition Banner will behave as follows:
1. Condition Banner will turn to Red color and Blinks irrespective of the color mode-
selected by the user. User configured color mode: “Alarm Blink” & “Blink in Red”
in the Setup Display screen will remain same. The operation field which displays the
alarm state of the system will also blink. When system returns to normal user config-
ured settings will be retained.
2. The Message text on the bottom of Condition Banner symbol and User defined text
on top of the Condition Banner symbol will be displayed as “ALARM” temporarily
as shown.
The Condition Banner can now be configured so that any of the Condition Banner
colors can be set to blink when that condition occurs. For example if an alarm occurs
the red color can be made to blink, similarly the yellow warning, green, and blue can
also be set to blink.
The Condition Banner configuration on the Display screen will have 3 options name-
ly: Active, Standby, and No Action for all four colors (Red, Yellow, Green, and Blue).
• When Active is selected, the Occupancy Status object of the SRCM will be active.
• When STANDBY is selected, then the unit shall be put into STANDBY mode (No
alarms will be generated) when the corresponding color condition is selected
• The No Action mode will take no action other than to display the Condition Banner
screen that has been associated with the No Action mode.
Alarms Cause
Condition Banner to
Turn Red
Condition Banner
Functions
Condition Banner –
Touch Screen
Operation