Brother HL-2170W - Manual (Page 368)

CHAPTER 9 HP-GL - 20
XT - X-axis tick
XT [;]
 Plots vertical tick marks as specified by the TL instruction from the current position.
 After plotting, the cursor returns to its point of origin.
 Plotting is performed whether the pen is up or down.
YT - Y-axis tick
YT [;]
 Plots horizontal tick marks as specified by the TL instruction from the current position.
 After plotting, the cursor returns to its point of origin.
 Plotting is performed whether the pen is up or down.
10 '*** XTYTEX ***
20 LPRINT "IN;PA300,279;SP2;PD";
30 LPRINT "PR1300,0;XT;PR1300,0;XT;PU;"
40 END
PT - Pen thickness select
PT [d] [;]
d : Fill line interval (mm)
 Sets the line interval when filling in with solid lines.
 The value for d is a clamped number from 0.0000 to 5.0000.
 The default value (0.3 mm) is used when d is omitted.
3.6.
Character Plot Instructions
Instruction Function
CS
Standard Set Definition
CA Alternate Set Definition
SS Select Standard Font
SA Select Alternate Font
DT Define Label Terminator
LB Define Label
DI Absolute Direction
DR Relative Direction
CP Character Plot
SI Set Absolute Character Size
SR Set Relative Character Size
SL Set Character Slant
UC User-defined Character
CS - Standard character set
CS n[;]
n ; Character set number(*)
 Specifies the standard character set.
 When the parameter field is omitted, character set 0 is specified.
 The value for n is a clamped integer number in the range of 0 to 4, 6 to 7, 9 or 30 to 39.
CA - Alternate character set
CA n[;]
n ; Character set number (*)
 Specifies the alternate character set.
 When the parameter field is omitted, character set 0 is specified.
 The value for n is a clamped integer number in the range of 0 to 4, 6 to 7, 9 or 30 to 39.