Brother MFC 8480DN - Manual (Page 134)

Control panel setup
123
6
Restoring the network settings to factory default
6
If you wish to reset the print server back to its default factory settings (resetting all information such as the
password and IP address information), please follow these steps:
Note
This function restores all wired and wireless network settings to the factory default.
a Press Menu.
b
Press a or b to choose Network.
Press OK.
c
Press a or b to choose Network Reset.
Press OK.
d Press 1 to choose Reset.
e
Press 1 to choose Yes for reboot.
f
The machine will re-start. You can now reconnect the network cable and configure the network settings
to work with your network.
Printing the Network Configuration List
6
Note
Node name: Node name appears on the Network Configuration List. The default node name is
“BRNxxxxxxxxxxxx” for a wired network or “BRWxxxxxxxxxxxx” for a wireless network. (“xxxxxxxxxxxx” is
your machine’s MAC Address / Ethernet Address.)
The Network Configuration List prints a report listing all the current network configuration including the
network print server settings.
a
Press Menu.
b
(For MFC model) Press a or b to choose Print Reports.
(For DCP model) Press a or b to choose Machine Info..
Press OK.
c
Press a or b to choose Network Config.
Press OK.
d Press Start.
Note
If the IP Address on the Network Configuration List shows 0.0.0.0, wait for one minute and try again.