Brother MFC-3320CN - Manual (Page 95)

A - 4 APPENDIX
NC9100h_FM6.0
Reloading firmware using BRAdmin Professional
utility
The BRAdmin Professional utility can be used to easily re-program
your Brother Print/Fax server.
1 Start BRAdmin Professional utility.
2 Highlight the appropriate Print/Fax server. Then press select the
Control menu and choose Load Firmware. You can select more
than one Print/Fax server by pressing CTRL+<select> or
SHIFT+<select> on each additional Print/Fax server.
There are three possible ways of sending the new software
version to the print server. For whichever method you select,
you must enter a password for the print server. The default
password for the Print/Fax server is
access .
3 TFTP PUT from this host
Use this method if you have TCP/IP already installed on your
PC. BRAdmin Professional utility will use the TFTP protocol to
send the new firmware data to the Print/Fax server.
AFTER SENDING FIRMWARE TO THE MACHINE, DO
NOT TURN OFF THE MACHINE UNTIL AFTER THE
MACHINE HAS PERFORMED AN AUTOMATIC RESTART.