Brother HL-7050N - Manual (Page 101)

8 - 2 DLC PRINTING
YL4US_FAX2800MFC4800-FM5.5
Configuring DLC on Windows ® NT/2000
To use DLC on Windows ® NT, you must first install the DLC protocol.
1 Log into Windows ® NT with administrative privileges. Go to the
NT Control Panel and double click on the Network icon.
Windows
® 2000 users select the properties of the Local Area
Connection.
2 On Windows ® NT 3.5x systems, select Add Software. On
Windows ® NT 4.0 systems, click on the Protocol tab, and click
Add. Windows ® 2000 users click the Install button from the
General tab.
3 Select DLC Protocol and then OK or Add if using Windows ®
2000. You may be asked for the location of the files. For Intel
based computers, the necessary files are stored in the i386
directory of the Windows
® NT CD-ROM. If you have a non-Intel
platform, specify the correct directory on your Windows ® NT
CD-ROM. Click Continue (for NT 3.5x systems) or Close (for
NT 4.0 systems).
4 Reboot your system to make the change take effect. Windows ®
2000 should not require a re-boot.
Windows ® 2000 Printer Setup
1 Log into Windows ® 2000 with administrative privileges. From
the Start menu, select Settings and then Printers.
2 Select Add Printer (If you have already installed a Brother
printer driver, double click the printer driver that you wish to
configure and then select Printers/Properties, select the Ports
tab, click on Add Port and continue from Step 6 (ignoring steps
11-14 about installing the correct driver)).
3 Click Next.
4 Select Local Printer and make sure that Automatically detect
and install my Plug and Play printer is not checked.
5 Click Next.