Brother HL-4040CDN - Manual (Page 179)

Troubleshooting
170
7
For Macintosh
®
with USB
7
Printing from DOS
7
BR-Script 3 (HL-4050CDN / HL-4070CDW only)
7
Problem Recommendation
The printer does not appear in
Print Center (Mac OS
®
X 10.2)
or Print Setup Utility (Mac
OS
®
X 10.3 or greater).
Make sure that the printer is turned on.
Make sure that the USB interface cable is connected correctly.
Make sure the printer driver is installed correctly.
Unable to print from the
application.
Make sure that the supplied Macintosh
®
printer driver is installed in the Hard Disk
and that it is chosen with Print Center (Mac OS
®
X 10.2) or Print Setup Utility
(Mac OS
®
X 10.3 or greater).
Problem Recommendation
Cannot print from an application. Make sure that the DOS application interface settings match those of your
printer. For example, if you are using a parallel printer cable, you would set
your DOS application printer port to LPT1.
Check if the printer has any printer alarms.
Make sure that you have chosen a printer driver in your application that is
supported by your Brother printer. (For information about the printers your
machine can emulate, see About emulation modes on page 68.)
Problem Recommendation
The print speed slows down. Add optional memory. (See Installing extra memory on page 95.)
The printer cannot print EPS data
that includes binary. You need the following settings to print EPS data:
a
For Windows Vista™: Click Start button, Control Panel, Hardware and
Sound, and then Printers.
For Windows
®
XP and Windows Server
®
2003: Click Start button, and
select Printers and Faxes windows.
For Windows
®
2000: Click Start button, and select Settings and then
Printers.
b
Right-click the Brother HL-4070CDW(HL-4050CDN) BR_Script3 series
icon and select Properties.
c
From the Device Settings tab, choose TBCP (Tagged binary
communication protocol) in Output Protocol.