Brother HL 2270DW - Manual (Page 31)

31
For Network Users
Web Based Management
(web browser)
The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
a
Open your browser.
b
Type http://machine_ip_address/ into
your browser (Where machine_ip_address
is the IP address or the print server name).
 For example http://192.168.1.2/
Reset the network settings to the
factory default
You can reset the print server back to its default
factory settings (resetting all information such as the
password and IP address information).
a
Turn off the machine.
b
Make sure that the front cover is closed and the
power cord is plugged in.
c
Hold down Go as you turn on the power switch.
Keep Go pressed down until all the LEDs light
up and then Ready LED turns off.
d
Release Go. Make sure that all the LEDs turn
off.
e
Press Go six times. Make sure that all the
LEDs light up to indicate the print server has
been reset to its factory default settings. The
machine will restart.
Print the Printer Settings Page
The Printer Settings Page lists all the current printer
settings, including network settings.
a
Make sure that the front cover is closed and the
power cord is plugged in.
b
Turn on the machine and wait until the machine
is in the Ready state.
c
Press Go three times within 2 seconds. The
machine will print the current printer settings
page.
Note
• The login name for the Administrator is ‘admin’
(case sensitive) and the default password is
‘access’.
• We recommend Microsoft ® Internet
Explorer ® 6.0 (or greater) or Firefox 3.0 (or
greater) for Windows ® and Safari 3.0 (or
greater) for Macintosh. Please also make sure
that JavaScript and Cookies are always
enabled in whichever browser you use. To use
a web browser, you will need to know the IP
Address of the print server. The IP Address of
the print server is listed on the Print Setting
Page.
See Web Based Management in the Network
User’s Guide.
Note
If the IP address on the Printer Settings Page
shows 0.0.0.0, wait for one minute and try again.