Brother PR-1000 - Manual (Page 6)

5
■ Positioning the pattern on thick fabric
When positioning the pattern on the fabric thicker than
2 mm, the fabric may not be detected correctly. In order
for the fabric to be correctly detected, its thickness must
first be measured.
a
Hoop the fabric in the embroidery frame, and
then attach the frame to the machine.
b
Select the pattern, and then press .
c
Display page 7/7 of the settings screen, and
then set “Fabric Thickness Sensor” to “ON”.
d
Press .
e
Press .
f
Affix the embroidery positioning sticker to the
fabric within the area indicated by the red
frame in the LCD, and then press
.
g
When the following message appears, remove
the embroidery positioning sticker, and then
press .
→ The embroidery positioning sticker affixed to the
fabric is detected, and then the embroidery frame
will be moved.
h
Continue with step
e
on page 4 to align the
pattern with the desired embroidery position.
Memo
• This feature is functional only when the fabric is
scanned. It will not affect embroidering if it is turned
on with normal embroidery.
CAUTION
• Use fabrics with a thickness of less than 3 mm
(approx. 1/8 inch). Using fabrics thicker than 3 mm
(approx. 1/8 inch) may cause the needle to break.