Brother HL 2270DW User Manual

Page 32

Advertising
background image

Control panel setup

28

5

Enabling or disabling the wireless network (For HL-2135W,

HL-2270DW and HL-2275DW)

5

If you want to switch the wireless network to enabled/disabled (disabled is the default), please follow these
steps:

a

Make sure that the power cord is plugged in.

b

Turn on the machine and wait until the machine is in the Ready state.

c

Hold down Go for 10 seconds. Release Go when the machine prints a Network Configuration page that
indicates the current network settings.

Note

If you release Go in less than 10 seconds, the machine will print if you have any reprint data.

d

Check the text to the right of IEEE 802.11b/g in the Node Type section. Active means that the wireless
setting is enabled and Inactive means that the wireless setting is disabled.

Note

You can switch the wireless network to enabled/disabled, using the BRAdmin applications or Web Based
Management (web browser). (For more information, see Other Management Utilities on page 6.)

<Node Type>
<Node Firmware Ver.>
<Ethernet Address>
<Node name>

<Active services>

Brother NC-XXXXw, IEEE 802.11b/g (Active)
Firmware Ver.0.20 (07.11.22)
XX-XX-XX-XX-XX-XX
BRWXXXXXXXXXXXX

BRNXXXXXXXXXXXX
BINARY_P1
TEXT_P1
POSTSCRIPT_P1
PCL_P1
BRNXXXXXXXXXXXX_AT

Advertising
This manual is related to the following products: