Brother HL-1870N - Manual (Page 115)

CHAPTER 12 TCP/IP CONFIGURATION
12-4
Using BRAdmin and the TCP/IP
Protocol
to set the IP address
If your PC has only the TCP/IP protocol, do the following:
1. Select TCP/IP filter in the left frame of the main window.
2. Select the "Device" menu and choose the "Search Active Devices".
If the print server is set to its factory default settings, it will not appear in the
BRAdmin screen, however, when you select the "Search Active Devices" option,
it will be found as an un-configured device.
3. Select the "Device" menu and choose the "Setup Unconfigured Device".
4. Select the MAC address of your print server and click the Configure
button.
You can find the node name and MAC address by printing out the printer
configuration page. Refer to the User’s Guide for information on how to print the
configuration page on your print server.
5. Input the IP address, Subnet mask and Gateway (If needed) of your print
server.
6. Click OK then select Close.
7. With the correctly programmed IP address, you will see the Brother print
server in the device list.
Using DHCP to Configure the IP
address
Dynamic Host Configuration Protocol (DHCP) is one of several automated
mechanisms for IP address allocation. If you have DHCP Server in your network
(typically a Unix, Windows NT/2000 or Novell Netware network) the print
server will automatically obtains its IP address from DHCP server and register its
name with any RFC 1001 and 1002-compliant dynamic name services.
If you do not want your print server configured via DHCP, BOOTP or RARP,
you must set the BOOT METHOD to static, this will prevent the print server
from trying to obtain an IP address from any of these systems. To change the
BOOT METHOD, use the printer control panel (for those printers that have a
LCD panel), TELNET (using the SET IP METHOD command), Web browser or
by using the BRAdmin application.