Brother HL-1870N - Manual (Page 27)

CHAPTER 1 UNIX PRINTING
1-11
DEC TCP/IP Servers for VMS(UCX)
You need to run the sys$system:ucx:$lprsetup command, specify a
printer name, and then enter the print server IP address as the remote system
name. Specify one of the print server services (see beginning of this section for
options) as the remote system printer name (accept the defaults for other
questions).
TGV's Multinet
TGV's Multinet requires you to run the MULTINET CONFIGURE /PRINTERS
command, then use the ADD command to add a printer, specifying the print
server IP address, a protocol type of LPD, and one of the service options
described at the beginning of this chapter as the remote print queue.
Wollongong's PATHWAY
First make sure that you have the Access option with lpd enabled. Then enter the
print server name and IP address in the TWG$TCP:[NETDIST.ETC]HOSTS
file, run the LPGEN program, and execute the command: add
queue/rmachine=prnservername/rprinter=prnserverservice
,
where queue is the name of the queue, prnservername is the print server
name from the hosts file, and prnserverservice is the print server service
name.
IBM AS/400
To use a Brother print server with an IBM AS/400 running IBM’s TCP/IP
gateways services for OS/400 (the OS/400 system must be v3.1 or later)
Use the CFGTCP command at your OS/400 prompt to add the print server’s
TCP/IP address to the AS/400 host table.
Use the following one-line OS/400 command to create the LPD queue:
CRTOUTQ OUTQ(<queuename> RMSTSYS
(*INTNETADR) RMTPRTQ(<service>)
AUTOSTRWTR(1) CNNTYPE(*IP) DESTTYPE (*OTHER)
MFRTYPMDL (<driver>)
INTNETADR(‘<ipaddress>’) TEXT
(‘<description>’)