Brother HL-1870N - Manual (Page 76)

CHAPTER 6 NOVELL NETWARE PRINTING
6-12
Configuring the Brother Print Server
(Queue Server Mode in Bindery
emulation mode) using PCONSOLE and
BRCONFIG
1. Login as Supervisor (NetWare 3.xx) or ADMIN (NetWare 4.1x or later;
be sure to specify the /b option for bindery mode).
2. Execute the BRCONFIG from the Windows menu
3. Select the corresponding server name from the list of print servers.
4. When you get the message that the print server is connected, type the
default password "access" in response to the "#" prompt (the password
will not echo), and then press the ENTER key in response to the Enter
Username> prompt.
5. When you get the Local> prompt, type:
6. SET NETWARE SERVER servername ENABLED
Where servername is the name of the file server on which the print
queue will reside. If there is more than one file server that you wish to
print from, repeat this command as many times as necessary.
7. Type EXIT to exit the BRCONFIG remote console program and save
the changes and start the Novell PCONSOLE utility.
8. Select print server Information (NetWare 3.xx) or print servers
(NetWare 4.1x; ignore the warning message) from the Available Options
menu.
9. You will be shown a list of current print servers. Press the INSERT key
to create a new entry, type in the NetWare print server name
(BRN_xxxxxx_P1 by default, where "xxxxxx" is the last six digits of the
Ethernet address) and press ENTER. Return to the main Available
Options menu by pressing ESCAPE.
10. Select the Print Queue Information (NetWare 3.xx) or Print Queues
(NetWare 4.1x) menu option to see list of configured print queues.
11. Press INSERT to create a new queue on the file server, type the new
queue name and press ENTER. The name does not have to be related to
the name of the print server resources, but should be short and
convenient for users to remember.
12. Make sure that the new queue name is highlighted, and then press
ENTER to configure the queue.
13. Select Queue Servers (in NetWare 4.1x, this item is called print servers)
and press ENTER to specify which network print servers can print jobs
from this print queue. The list will be empty, since none have been
selected yet if this is a new queue.
14. Press INSERT to get a list of the queue server candidates and select the
print server service name from step 11, Press ENTER.
15. Press ESCAPE several times until you return to the Available Options
menu.