Canon XEED SX6000 - Manual (Page 121)

121
Setting Various Functions
User’s Manual
Settin
g
Functions from Menus
Skip the POWER Button
Operation
[Direct power on]
You can turn on the projector by connect-
ing the power cable without pressing the
POWER button.
MENU > [System settings] > [Direct power on]
MENU > [System settings] > [Direct power on]
Press the OK button to accept your setting
and then press the MENU button or EXIT
button (WX6000 / SX6000).
• [Off] is the factory default.
HDMI Component
Digital PC Analog PC
Off You need to press the POWER button
to turn on the projector.
On You can turn on the projector by con-
necting the power cable only.
• Before setting the direct power on to
[On], be sure to set the [Power man-
agement mode] to [Standby] or
[Exit].
• After turning off the projector, wait at
least 5 minutes before turning it on
again. It may shorten the lamp life if
you turn on the projector immediately
after turning it off.