Setting projector information [projector info, Setting up the network – Canon XEED SX6000 User Manual

Page 186

Advertising
background image

Setting Up the Network

186

Setting Projector Information [Projector info.]

From [Projector info.] in the settings window, you can set the names and location
names which are used to identify projectors when multiple projectors are installed on
the network. For the setting procedure, refer to

page 177

.

Item

Explanation

Factory default setting

SNMP

Select the SNMP function version. If OFF is
selected, the SNMP function will be turned
off and the other settings in this window
cannot be changed.

OFF

Receive community

Enter the community name which will
receive projector information in 1-byte
alphanumeric characters and symbols (1 -
15 characters).

<Blank>

Password

Enter the community settings password in
1-byte alphanumeric characters and sym-
bols (8 - 15 characters). This is also used
as the password for trapping. It can be set
only when the SNMP version is V3.

<Blank>

Confirm password

For confirmation, enter the same password
as you entered in [Password].

<Blank>

SNMP trap

Select the type of error to trap. When any of
the checkboxes is turned on, it becomes
possible to set [Trap IP address] and [Trap
community].

OFF (no checkmarks)

Trap IP address

Enter the IP address to send information to
when trap occurs. Enter in 1-byte numbers.

0.0.0.0

Trap community

Enter the community name which will send
information when trap occurs. Enter in 1-
byte alphanumeric characters and symbols
(1 - 15 characters).

<Blank>

Item

Explanation

Factory default setting

Projector name

Enter the projector name in 1-byte alphanu-
meric characters and symbols (1 - 63 char-
acters).

WUX5000 / WUX4000 /
WX6000 / SX6000

Location

Enter the projector installation location in 1-
byte alphanumeric characters and symbols
(0 - 63 characters).

<Blank>

Advertising