Canon XEED SX6000 - Manual (Page 194)

Cleaning and Replacing the Air Filter
194
5
Securely insert the air filter all the way
into the projector.
Cleaning the Air Filter
The air filter protects the lens and mirror inside the projector from dust and dirt. Should
the air filter become clogged with dust, the projector may be damaged since it will block
the air flow into the projector and raise the internal temperature of the projector. The fol-
lowing screen is displayed when turning on the projector if the air filter needs to be
cleaned (after approx. 300 hours). Clean the air filter if it is displayed.
• Turn the power of the projector off and pull out the power plug.
• Hook your finger into the air filter handle on the side of the projector, and remove the air
filter. Then use a vacuum cleaner to remove the dust.
• If the filter replacement screen is displayed when turning on the projector after cleaning
the air filter, select [Yes] and press OK. The filter replacement screen will disappear.
• This screen is not displayed when [Filter warning display] is set to [Off]. (WX6000 /
SX6000) ( P137 )
• Handle the air filter carefully. If damaged, the air filter will not work properly.
• When the lamp is replaced, it is recommend that you also replace the air filter.
• Contact the Canon Customer Support Center for further information.
• Replacement air filter part No.: RS-FL01
• This can also be purchased from the Canon home page
(http://store.canon.jp/user/ListProducts/list?svid=2&sc=LMPPR&jsp=/jsp/search/
search_item_acc.jsp).
• Only the [ ], [ ], OK and POWER buttons are
available while this screen is displayed. (When you
press the
POWER button, the message “Push
POWER button again to turn off power” appears.)
• When this screen has disappeared after being dis-
played for 10 seconds, all buttons become opera-
ble.