Canon XEED SX6000 - Manual (Page 100)

Setting Display Status
100
Select HDMI Over Scan
[HDMI over scan]
You can select this as required when you
project visual software using an HDMI sig-
nal.
MENU > [Display settings] > [HDMI over scan]
MENU > [Input settings] > [HDMI over scan]
Press the OK button to accept your setting
and then press the MENU button or EXIT
button (WX6000 / SX6000).
• The factory defaults settings are [On]
when [HDMI In] ( P127 ) is set for [Auto]
and [Off] when it is set for [Computer].
HDMI Component
Digital PC Analog PC
Off The entire input signal (100%) is pro-
jected. The images projected may be
smaller than the full projection screen.
On Images are projected with distortion
at the peripheral section of images
trimmed off. (The central 95% of the
images are projected.)
Part of the peripheral sections of
images may be cut out depending on
the resolution of the signal. In such a
case, select [Off].