Canon XEED SX6000 - Manual (Page 146)

146
Installation Precautions
Precautions When Carrying the Projector
Installation Precautions
Be sure to read on page 12 – 24 . Pay attention to the following when installing the
projector.
Precautions When Carrying and Transporting the Pro-
jector
Prepare the projector as described below before carrying it.
• Disconnect the cables connected to the projector. Carrying
the projector with the cables attached may cause an acci-
dent.
• Retract the adjustable feet.
• When the projector is transported after the lens unit is
installed, be sure that you do not grasp the lens while trans-
porting it. Doing so may damage the projector.
• Do not strike the projector or
subject it to impact. Doing so
may cause a malfunction.
• Do not install the projector so
that it is inclined or standing
vertically. The projector may tip
over, causing damage.
• Do not block the cooling fan
intake or exhaust vent. If the intake or exhaust vent is
blocked, heat may accumulate inside the projector, causing
a malfunction.
• Do not reuse any packaging or shock-absorbent materials
that were supplied with the projector at the time of purchase
for transporting or shipping the projector. Protection of the
projector cannot be guaranteed if used packaging or shock-
absorbent materials are reused. Fragments from shock-
absorbent material may also enter the interior of the projec-
tor which could cause a malfunction.
• If transportation is necessary, the lens unit should be
removed before transporting the projector. If the projector is
subjected to excessive impacts during transportation, the
lens unit may be damaged. Removal and installation of the
lens unit should not be performed by the user. Be sure to
have the procedure performed by a qualified technician or
contact the Canon Customer Support Center.
Exhaust
Intake