Canon VB-M700F - Manual (Page 122)

122
„ Warning Messages in the Viewer
Message Cause
Viewer window The time on this machine is out-of-sync with the
time used by the storage server group. This
causes problems with the display of events. To
correct this problem, please synchronize the time
of this machine to the server group. There is a time difference of 5 seconds or longer
between the Storage Server and the Viewer
computer. Adjust the system time of the Viewer
computer to the time of the Storage Server.
This message is not displayed if the [Send
notification when time is out-of-sync with the
storage server group] checkbox is cleared in the
[Viewer Settings] dialog box (p. 60).
Event notification Invalid E-mail Address. Characters other than alphanumeric characters
and the underscore (_) were entered for the e-mail
address.
The SMTP server port is invalid. Please specify a
value between 1 and 65535. An invalid SMTP server port number was entered.
The POP server port is invalid. Please specify a
value between 1 and 65535. An invalid POP server port number was entered.
User management The user name already exists. Tried adding a user to the Storage Server with a
name that already exists.
Unable to change the user name. The user '<user
name>' already exists. Tried adding a user name on the Storage Server to
a name that already exists.
Please ensure that the password and confirmation
match exactly. The password in the [Confirm Password] field does
not match the user password.
Are you sure you want to remove this user? Tried to delete a user.
The number of connecting viewers has exceeded
the recommended number, and the recording
server is under high load. Tried connecting 7 or more Viewers at one time.
Configuration The value for maximum must be greater than or
equal to 1 day. Tried to specify less than one day for the maximum
storage period.
Adding a recording schedule Streaming for recording is applied only when the
following conditions are satisfied:
– the video stream format is JPEG
– the frame rate settings do not exceed 10 fps
– there is no existing recording-mode stream in
the camera.
Tried to enable a recording-mode stream.