Canon VB-M700F - Manual (Page 82)

82
(2) [Settings Mode]
• [Simple]
[Sensitivity] and [Area Ratio] can only be set using
the sliders. [Duration] is fixed at 0.2 seconds.
• [Advanced]
Makes the [Sensitivity], [Area Ratio] and [Duration]
settings available so that values can be set.
(3) [Sensitivity]
Specify the motion detection sensitivity within the
range of 1 to 256. Increase the number to increase the
sensitivity.
(4) [Area Ratio]
Specify the area of the preview video that the Storage
Server uses for motion detection. The range is 0 to
100%. The size marker inside the Detection Indicator
changes position depending on the value of this
setting.
(5) [Duration]
Specify the length of time the motion signal must be
present to decide that there is motion. The range is 0
to 5.0 seconds.
(6) [Active Region]
Displays a preview video from the camera used for
motion detection.
Displays a dotted-line frame representing the active
region on top of the preview video. Drag the frame
handles to make it larger or smaller.
(7) [Detection Indicator]
The size marker changes position depending on the
value of the [Area Ratio] setting. Adjust the motion
detection settings while viewing the preview video
and the Detection Indicator.
The colored bar changes depending on the value of
the [Sensitivity] and the [Area Ratio] settings.
You cannot specify motion detection on the camera.
Color of the
Colored Bar
Meaning
Green The detected motion does not exceed the
values specified in [Sensitivity] and [Area
Ratio]. In this case, the colored bar
remains to the left of the size marker.
Red The detected motion exceeds the values
specified in [Sensitivity] and [Area Ratio].
In this case, the colored bar remains to the
right of the size marker.
Size marker
Colored bar
Important
• If the recording period for a schedule ends while motion
detection recording is in progress, recording will stop.
• The detection indicator is not affected by the [Duration]
setting. Be sure to take the detection time into account when
adjusting the motion detection settings.
• To perform motion detection on the Storage Server, you must
specify [JPEG] for the [Video Format]. Also, if you
simultaneously use more than one recording mode, all the
[Video Format] settings must be [JPEG]. An error message is
displayed if you try to use a format other than [JPEG] and
motion detection on the Storage Server at the same time.
• Make the [Priority] setting on the [Recording Settings] tab
lower than the priority of any of the other recording settings.