Canon DP-V3010 - Manual (Page 12)

12 Nomenclature
■ Interface
Left side Right side
7
A g
8
9
A q
A
a
A s
A
d
A f
A h
A j
7A a 3G/HD-SDI input
terminal 1 Two input systems
corresponding to input 1.
8A s 3G/HD-SDI
output terminal 1 Monitor output
corresponding to 7A
a
9A d 3G/HD-SDI input
terminal 2 Two input systems
corresponding to input 2.
A qA f 3G/HD-SDI
output terminal 2 Monitor output
corresponding to 9A
d
A g LAN (10/100
BASE) terminal Connects to display
controller.
The main unit connects
1 to 1 with the display
controller. It can also be
connected via a hub.
A h USB port Used to connect external
sensor for calibration
(
28) or USB memory for
export/import ( 29).
A j DisplayPort input
terminal One input system
available.
CAUTION
• When connecting an external sensor for calibration to the USB port, cable length must not exceed 3 m. Otherwise,
communication error may occur and correct calibration may not be possible.
• Directly connect external sensors and USB memory without using a hub.
Note
• Dual Link HD-SDI is used for connecting two input systems ( 16, 17)
• Both FAT16 and FAT32 USB memory devices are supported.
• Proper operation cannot be guaranteed for all USB memories.
• It may take 10 seconds or more for the USB memory to be recognized. When "Settings Export/Import" is executed while
the USB memory is being recognized, the message "Detecting USB memory." will be displayed.
COP
Y