Canon DP-V3010 - Manual (Page 19)

19 Installation/Connection
Connecting the Main Unit to the Display Controller
This section describes how to connect the main unit to the display controller.
CAUTION
• When using a commercially available LAN cable, please use a shielded type cable no longer than 3 m in order to prevent
malfunction due to noise.
1. Open the lid on the back of the display controller.
While holding the display controller with one hand, place your finger in the cutout portion of the lid and pull forward.
Lid
Cutout
2. Connect the supplied LAN cable LN-30 and the compact power adapter CA-PS700.
Insert the connector of the LAN cable LN-30 and plug of the compact power adapter CA-PS700 as shown in the
figure below. Use the cutout section to pass the cables, as illustrated.
LAN Cable
LN-30 Compact Power Adapter
CA-PS700
3. Close the lid with cables hanging out from the cutout area.
4. Connect the other end of the LAN cable to the LAN terminal of the main unit.
COP
Y