Canon DP-V3010 - Manual (Page 26)

26 Operating the Display Controller
Using the Channel (CH) Button
You can assign channels (various settings related to input signal) to the CH buttons on the display controller and switch
channels instantly.
1. Press the MENU button to open the OSD menu.
2. Select "System Settings"→"Display Controller Channel" and press the SET button.
A new window opens and displays button names CH1 to CH4.
3. Select a button name with the buttons and press the SET button.
The selection frame moves to next OSD menu level.
4. Select the channel to assign with .
See "Channel Settings" ( 39) for the configurable settings.
5. Press the SET button.
The setting is confirmed.
The channel buttons on the display controller are preset with the following factory defaults.
CH1 CH2 CH3 CH4
Input Configuration 3G-SDI 1 3G-SDI 2 Dual Link
HD-SDI
DisplayPort
Select Input Signal 4K Input 4K Input 4K Input 4K Input
Format Automatic Automatic Automatic Automatic
Color Range Full Full Full Automatic
Internal Sync Off Off Off Off
Picture Mode DCI DCI DCI DCI
Channel Name (Blank) (Blank) (Blank) (Blank)
Checking Signal Information and Status of the Main Unit
The video display is equipped with a banner display function which can be used at any time to check signal information
or the status of the main unit.
1. Press the SET button when the OSD menu is closed.
The channel name, signal information, and status of the main unit will be displayed in the banner. It will automatically
disappear after 4 seconds.
Note
• For more detailed signal information, please refer to the section on "Signal Information" ( 52).
• The "Detecting sync." banner will continue to appear until synchronized (it may take 4 seconds or more).
COP
Y