Canon DP-V3010 - Manual (Page 28)

28 Using the OSD Menu
Adjusting Image Quality While Viewing the Entire Image
You can adjust the OSD menu to display as a slider at the bottom of the screen. This allows for the image quality to be
adjusted whilst it is displayed on the screen. The following items can be adjusted:
• Contrast
• Brightness
• Chroma
• Sharpness
• Color Temperature (x, y)
1. Press the SET button when the selection frame is on setting options.
A slider appears at the bottom of the screen.
2. Use the slider as guide and adjust with buttons.
3. Press the SET button when finished.
The screen returns to the original OSD menu.
Calibration without a PC ( 37)
When "User 1-7" is selected in "Picture Mode", you can adjust the image quality to the desired target value set in the
OSD menu using an external sensor.
The supported external sensors are Konika Minolta Display Color Analyzers CA-310 and CA-210. Be sure to also read
the instruction manual of the CA-310 and CA-210.
1. Connect the display color analyzer to the USB port of the main unit.
2. Open the OSD menu and select "Adjustment"→"Calibration".
Set each target value.
3. Select "Start" with the SET button.
Please follow the information indicated on the screen.
4. Initialize the sensor.
Set the mode dial of the Universal Measuring Probe to "0-CAL".
Select "OK" with the SET button on the and perform initialization.
5. Place the sensor facing the center of the main unit.
Set the mode dial of the Universal Measuring Probe to "MEAS" and place the probe as shown below according to
the displayed content. Select "OK" with the SET button on the display controller and perform calibration.
Konica Minolta Universal Measuring Probe
CA-310 support: CA-PU32 / CA-PU35
CA-210 support: CA-PU12 / CA-PU15
Konica Minolta
Display Color Analyzer CA-310 / CA-
210
Main Unit
COP
Y