Canon EOS C500 PL - Manual (Page 17)

17
A user name and password are required before the Wi-Fi Remote application (Wi-Fi-enabled
device connected to the Wi-Fi network) can access the transmitter in order to operate the
camcorder. Additionally, you can set a unique camcorder identification code and designate the
port that Wi-Fi Remote should use. The Wi-Fi connection will be disabled while you change
these settings.
[User Name]*, [Password]* Protect the remote operation of the camcorder with a user name
and password.
[Port No.] The port number (HTTP protocol) used by Wi-Fi Remote. This is
usually set to port 80, but you can change it if necessary.
[Camera ID] Set a unique camcorder identification code that will appear on the
Wi-Fi Remote screen. This is convenient if you are using a multi-
camera shooting setup.
* Required settings.
1
Open the [Camera Settings] submenu.
[w Other Functions] > [Wi-Fi Remote] > [Camera
Settings]
2
Select the desired setting and then
press SET.
3
Enter the desired value as described
below.
If necessary, repeat steps 2 and 3 to set additional
settings. When you finish changing the settings,
select [L], press SET and then close the menu.
When you close the menu after changing the
camcorder’s settings, the camcorder will reconnect
to the Wi-Fi network using the new settings.
[User Name], [Password], [Camera ID]
1 Use the joystick or turn the SELECT dial to select a character and then press SET
to add it.
Repeat this step as necessary to enter the necessary text.
2 After entering the desired text, select [OK] and then press SET.
[Port No.]
1 Push the joystick up/down or turn the SELECT dial to select a value for the first
field and then press SET to move to the next field.
2 After completing all the fields, select [Set] and press SET to enter the port number.
Camcorder Settings
COP
Y