Canon RM-Software - Manual (Page 67)

Configure the Video Window Layout
67
Viewer
S
et
tin
g
s
4
Save the Layout
After configuring the display and position of the video
windows, follow these steps to save the layout.
Configure a Dynamic Layout
➀ [Layout Name]
Enter the name of the dynamic layout.
➁ [Display cameras that]
Specify the display criteria for cameras.
Click a check box to make a set of display criteria
available, and then click each criteria list to select the
criteria.
You can specify up to five sets of criteria.
The criteria are (from left to right), the property,
operator, and status.
Select [All of the following are met] to display only
cameras that meet all the criteria. Select [Any of the
following are met] to display cameras that meet any of
the criteria.
➂ [When conditions are not met, continue displaying
cameras for]
Specify how long a video window in the layout will
remain displayed when it does not match the criteria
specified here.
➃ [OK] and [Cancel]
Close the dialog box.
1 Click [File] > [Save Layout].
2 Change the layout name as required, and click [OK].
1 Click [Layouts] > [New Dynamic Layout] to display the
[New Dynamic Layout] dialog box.
2 Specify the criteria for the video windows displayed in
the dynamic layout.
➁
➂
➀
➃
Property
Operator for the
decision
Status
Tags is
isn’t Camera tags
Status is
isn’t Camera status
(such as
[Recording],
[Idle], or [Error])
Event Type is
isn’t Event type (such
as [Motion] or
[Sensor])
Event Priority is
is equal or higher than
is equal or lower than Event priority
([Highest], [High],
[Medium], [Low],
or [Lowest])
Storage
Server Group is
isn’t The name of
Storage Server
Group to which
the Viewer is
connected.
3 Click [OK] to close the dialog box.
4 Click [File] > [Save Layout].
5 Change the layout name as required and click [OK].
Property
Operator
Status