Canon XF305 - Manual (Page 105)

105
Recording 3
Special Recording Modes
• The time code advances by the number of frames recorded. If the
running mode of the time code (0 82) is set to [Free Run] or the time
code is input from an external source (b only), the running mode
will switch to [Rec Run] during special recording mode. When special
recording mode is deactivated, the running mode will return to its
previous setting.
• b During special recording mode, the time code signal will not
be output from the TIME CODE terminal or HD/SD SDI terminal.
Slow & Fast Motion Mode
When you set [J Other Functions] [Frame Rate] to a progressive
frame rate (0 51), the camcorder can record with a frame rate (shooting
frame rate) that is different from the playback frame rate. Recording a clip
at a higher frame rate than the [Frame Rate] setting will result in a slow
motion effect during playback. Conversely, a lower frame rate will result in
a fast motion effect.
Sound is not recorded in this mode. This mode is not available if [J Other
Functions]
[Bit Rate/Resolution] is set to [35 Mbps 1440x1080].
Configuring Slow & Fast Motion Mode
1 Open the [S&F Frame Rate] submenu.
[J Other Functions] [Slow & Fast Motion] [S&F Frame Rate]
2 Select the desired shooting frame rate and then press SET.
Available Shooting Frame Rates
* Available only when [J Other Functions] [Bit Rate/Resolution] is set to
[50 Mbps 1280x720] or [35 Mbps 1280x720].
Activating Slow & Fast Motion Mode and Recording
1 Open the [Special Rec] submenu.
[J Other Functions] [Special Rec]
2 Select [Slow & Fast Motion] and then press SET.
• [S&F STBY] appears at the top of the screen.
• The selected shooting frame rate appears on the right side of the
screen next to the [J Other Functions] [Frame Rate] setting (the
playback frame rate).
[J Other Functions]
[ Slow & Fast Motion]
[S&F Frame Rate]
12 15 18 20 21 22 23 24 25 26*
27* 28* 30* 32* 34* 37* 42* 45* 48* 50*
[J Other Functions]
[ Special Rec]
[Off]
Shooting frame rate
Playback frame rate
COP
Y