Canon Wireless File Transmitter WFT-E7A - Manual (Page 95)

95
Connecting GPS Devices via Bluetooth
4 When the confirmation message is
displayed, select [OK].
The GPS connection status changes to
[Connected]. Pressing <0> under these
conditions will enable you to disconnect the GPS
device.
While the Bluetooth connection is active, <s> is
displayed on the transmitter’s LCD panel and
<r> is displayed on the camera’s LCD panel.
5 Confirm operation of the GPS device.
Make sure the GPS device has determined the
current location.
6 Take the picture.
After confirming that <r> is shown on the
camera’s LCD panel, shoot when ready.
If the <r> icon is blinking when you shoot,
accurate GPS data will not be added to images.
7 Check the GPS data.
Play back the image in single image display.
Press the <6> button to display the shooting
information screen with GPS data.
From top to bottom: latitude, longitude,
altitude, and Coordinated Universal Time
When the camera’s power is turned off and on or when it wakes up from auto power off, do not shoot
until the <r> icon remains displayed. If you shoot while the icon is blinking, the correct GPS
information may not be added to images.
The date and time indicated is the Coordinated Universal Time (UTC) as obtained by the GPS device,
which is nearly the same as Greenwich Mean Time (GMT). In some cases, the date and time of the
zone specified on the GPS device is indicated.
COP
Y