Canon imageCLASS MF7470 - Manual (Page 124)

1
2
3
4
5
6
7
8
9
10
11
4-13
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Scan Settings
Selecting a Scan Mode
The machine has three preset scan modes:
B&W 200 x 200 dpi, B&W 300 x 300 dpi, and Color 300 x 300 dpi)
(for the imageCLASS MF7480)
200 x 200 dpi (Fine), 200 x 400 dpi (SuperFine), and 400 x 400 dpi
(UltraFine) (for the imageCLASS MF7470/MF7460)
Select the desired mode from the preset scan modes according to
the type of original you are sending.
If the destination is a fax number or I-fax address, the original is always
scanned and sent in B&W mode.
If you want to use less memory and make the sending time shorter, use a
low-resolution mode.
In addition to the scan mode, you can store addresses and other send
settings in the favorites buttons. (See “Storing/Editing Favorites Buttons,”
on p. 4-60.)
1. Press (SEND).
2. Place your originals.
3. Specify the destination.
4.
Press [Scan Settings].
■
–
–
–
–
–
5. From the Scan Settings drop-down list, select a
scan mode.
The following combinations of file format and preset scan modes
are not available. If you select them, a message asking for your
confirmation to change the file format appears on the screen
when you press (Start).
[PDF (Compact)] or [JPEG] as the file format and [B&W 200 x
200 dpi] or [B&W 300 x 300 dpi] as the scan mode.
[TIFF] or [PDF] as the file format and [Color 300 x 300 dpi] as
the scan mode.
[Color 300 x 300 dpi] is not available when sending faxes or
I-faxes.
To change the Scan mode settings, select [Option] from the Scan
Settings drop-down list, and adjust the settings.
6. Press (Start).
If the original is placed on the platen glass, follow the instructions
that appear on the touch panel display, then press (Start) once for
each original. When scanning is complete, press [Done].
Scanning starts.
The scanned data is sent to the specified destination when scanning
is complete.
To cancel the scan settings, press [Scan Settings], then [Option],
then [Cancel].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
–
–
–
–
–
–
–